The product can be applied on the above surfaces, with rough, antiqued or cleft finishes.
The product is not suitable for use on buffed, fine polished or excessively compact surfaces with low absorption.

CHARACTERISTICS AND BENEFITS

•  Brings out the characteristic veins of the surface
•  Excellent stain-proofing properties
•  Colour-enhancing
•  Increases surface resistance to foot traffic
•  Makes cleaning and maintenance operations much simpler
•  Will not yellow over time
•  Creates a highly resistant glossy protective layer

This product can be used on both indoor and outdoor surfaces.
Suitable for use on: Marble-cement agglomerate, Slate, Sandstone, Cementine, Concrete, Cotto,
Granite, Marble, Exposed brickwork, Reconstituted (eco) stone, Porphyry, Quarzite, Terracotta,
and Travertine.

The product can be applied on the above surfaces, with rough, antiqued or cleft finishes.

The product is not suitable for use on buffed, fine polished or excessively compact surfaces with
low absorption

15/20 m2/l

Brush, Lambswool applicator, Roller

Preparing and cleaning the surface

1. Carefully clean the surface, making sure to remove any dust or dirt present.

2. Never apply AS 930 to wet or damp surfaces.

4. Apply AS 930 to surfaces with a temperature of between +5 and +40°C

5. Any adjacent surfaces not being treated with the product must be protected.

Application 

6. Apply an even, light coat of product to a clean, dry surface with the preferred tool, making
sure to create an even layer to cover the whole surface being treated and trying to treat the
area in the smallest amount of time possible so that the film can cure spontaneously without
any intervention on areas already completed.

7. If there are any differences in shine during the drying stages, due to the different degree of
absorption on the surface, do not try to even out the product; wait for it to cure completely
(about 4-6 hours) and then repeat the application following the same process as described
above, trying to even out the appearance of the surface.

Drying time

The product is fast drying and in any case, within 45 minutes from application.

Opening to floor traffic

The surface can be opened to floor traffic about 4-6 hours after the product has been applied.

Complementary Cleaning and Maintenace Products

– For routine cleaning of a surface treated with AS 930, we recommend: NEUGEL

– For routine cleaning of a surface treated with AS 930, we recommend: NEUGEL

– For de-waxing a surface treated with AS 930, we recommend: DEC 21 and/or DECERA P

CLICK HERE