CHARACTERISTICS AND BENEFITS

•  Restores the original appearance of the material without spoiling the surface
•  Quick and easy application
•  Even looking finished results
•  Water-based product.
•  No defects through overlapping

This product can be used on both indoor and outdoor surfaces.
This product is suitable for use on: Full-body polished porcelain tiles, Glazed polished porcelain
tiles (Lappato), Glazed surfaces

20/30 m2/L

Single disc machine with at least 1.5 HP; manual rotary brush.

Faber Chimica is able to supply the WARRIOR single disc machine, which has a power of 2.2 HP,
and is optimised for the correct application of any product.

Preparing and cleaning the surface

1. Carefully clean the surface, making sure to remove any dust or dirt present. We suggest to
use our DETERFUG or our FABER 30, depending on the nature of dirt and the surface type.

2. We suggest to apply the product on surface sections of 2 m2 at a time.

4. Apply the product to surfaces with a temperature of between +5 and +40°C

5. Any adjacent surfaces not being treated with the product must be protected.

Application 

6. Shake the bottle well before used and pour 2/3 spoons of product onto the surface to be
treated. This amount is sufficient to treat a surface area of about 2 m2.

7. Add a small amount of water to the cream. As a rough guide, each spoonful of product
requires around 1 spoon of water.

8. As soon as the water has been added to the cream, proceed to apply it to the surface using
the single disc machine, fitted with white pad and set to between 150 and 200 r.p.m. Continue
with the single disc machine, taking care to cover the whole surface area evenly with the cream.
Try to pass over each section of floor the same number of times.

9. During the application process, the mix must maintain its creamy consistency and therefore,
if it should become too dry, gradually add a some drops of water.

10. Continue to pass over the surface with the polisher until the result is as required. This is
easy to check during application by removing a small area of product using a squeegee mop or
similar, and checking the surface finish.

11. Once the required result has been achieved, vacuum or remove any residues from the
surface and rinse with plenty of clean water.

Generally, PORCELAIN RESTORATION CREAM will restore the surface within 15-25 passages, but
always checks depending on the type of surface

Drying time

12. After carefully removing any residues and rinsing
the surface with water, no further waiting time is necessary.

Opening to floor traffic

13. After carefully removing any residues and rinsing the surface with water, the floor can be
opened for use.