CHARACTERISTICS AND BENEFITS

•  A versatile product, suitable for use on different types of material
•  Ready to use
•  Does not change the surface hardness of the support
•  Adds excellent surface resistance to dirt
•  Lasting protection against dirt and foot traffic
•  Effectively restores scratches, scuffs and chemical aggression
•  Water-based product
•  Quick and easy application
•  Wax free

This product can be used on both indoor and outdoor surfaces.
Suitable for use on: marble, limestone, travertine; marble-cement agglomerates; marble-resin
agglomerates, glazed ceramics, and lapped porcelain stoneware.

40/50 m2/kg

Single disc machine with at least 1.5 HP; manual rotary brush.

Faber Chimica is able to supply the WARRIOR single disc machine, which has a power of 2.2 HP,
and is optimised for the correct application of any product.

Preparing and cleaning the surface

1. Carefully clean the surface, making sure to remove any dust or dirt present.

2. When applying to marble or lime-based materials, we recommend proceeding to apply the
product in stages, covering surfaces approximately 2m2 at a time. In case of use of ceramic or
stoneware, it is possible to apply without limits to area size.

3. Never apply K100 to wet surfaces. K100 can be used on slightly damp surfaces; therefore,
please ensure that the surface to be treated is as dry as possible.

4. Apply K100 to surfaces with a temperature of between +5 and +40°C

5. Any adjacent surfaces not being treated with the product must be protected.

Application 

6. Shake the bottle well before used and pour 2/3 spoons of product onto the surface to be
treated. This amount is sufficient to treat a surface area of about 2 m2.

7. Add a small amount of water to the cream. As a rough guide, each spoonful of product
requires around 1 spoon of water.

8. As soon as the water has been added to the cream, proceed to apply it to the surface using
the single disc machine, fitted with white pad and set to between 150 and 200 r.p.m. Continue
with the single disc machine, taking care to cover the whole surface area evenly with the cream.
Try to pass over each section of floor the same number of times.

9. During the application process, the mix must maintain its creamy consistency and therefore,
if it should become too dry, gradually add a little water.

10. Continue to pass over the surface with the polisher until the result is as required. This is
easy to check during application by removing a small area of product using a squeegee mop or
similar, and checking the surface finish.

11. Once the required result has been achieved, vacuum or remove any residues from the
surface and rinse with plenty of clean water.

Generally, K100 will achieve the desired result within 15-25 passages of the polisher,
independently of the type of surface.

Drying time

12. After carefully removing any residues and rinsing the surface with water, no further waiting
time is necessary.

Opening to floor traffic

13. After carefully removing any residues and rinsing the surface with water, the floor can be
opened for use.

Complementary Cleaning and Maintenace Products

– For routine cleaning of a surface treated with K100, we recommend: NEUGEL or ALGAFLOOR

– For extraordinary cleaning of a surface treated with K100, we recommend: FABER 30 on
marble or lime-based materials or DETERFUG on ceramic or stoneware