CHARACTERISTICS AND BENEFITS

•  Drastically reduces the dirt on surfaces
•  Makes cleaning operations much easier
•  Does not change the surface hardness of the support
•  Quick and easy application
•  Even looking finished results
•  Sealing action on material porousness
•  Increases surface resistance to foot traffic
•  Water-based product.
•  Wax free
•  No defects through overlapping

This product can be used on both indoor and outdoor surfaces.
This product is suitable for use on: quartz-resin agglomerates, granite, full-body polished
ceramic porcelain, glazed polished ceramic porcelain (gres lappato)

TCB 12 is suitable for application on all siliceous materials that have lost part of their shine due
to wear or foot traffic.

50/70 m2/l

Single disc machine, which has a power of 2 HP (2.2 HP is preferable); Manual rotary brush
Faber Chimica is able to supply the WARRIOR single disc machine, which has a power of 2.2 HP,
and is optimised for the correct application of any product.

Preparing and cleaning the surface

1. Carefully clean the surface, making sure to remove any dust or dirt present.

2. We recommend proceeding to apply the product in stages, covering surfaces approximately 1
m2 at a time.

3. Never apply TCB 12 to wet surfaces. TCB 12 can be used on slightly damp surfaces; therefore,
please ensure that the surface to be treated is as dry as possible.

4. Apply TCB 12 to surfaces with a temperature of between +5 and +40°C5. Apply TCB 12 to
surfaces with a temperature of between +5 and +40°C

5. Any adjacent surfaces not being treated with the product must be protected.

Application 

6. Pour a small amount of product directly onto the area to be polished. Generally, about 2/3
spoonfuls of product are enough to polish a surface area of 1 m2.

7. As soon as the product has been poured on, proceed to apply it to the surface using the
single disc machine, fitted with white pad and set to between 150 and 200 r.p.m. Pass the single
disc machine using concentric movements so as to distribute the product evenly over the whole
section being treated.

8. Continue to polish the same area until the product has dried completely (Dry Buffing
technique), taking care to broaden the movements outwards from the centre of the section so
as to cover the whole area evenly.

9. Pass on to the next section, repeating the polishing treatment process as described above.

For better shine or to increase the sealing action of the material and therefore, its resistance to
dirt, repeat the application of the product following the same method stated above. Generally,
we recommend treating the same area with 1 or 2 applications of product, as required. The
product formulation will not cause overlap blemishes and therefore, once the maximum surface
shine has been achieved, there will be no difference or defects between the various areas
treated separately.

Drying time

11. After the product is completely dry, no further waiting time is necessary.

Opening to floor traffic

12. After the product is completely dry, the floor can be opened for use.

Complementary Cleaning and Maintenace Products

– For routine cleaning of a surface treated with TCB 12, we recommend: ALGAFLOOR or NEUGEL
based on the type of material

– For extraordinary cleaning and for preliminary removal of wax for a surface treated with TCB
12, we recommend: FABER 30 or DETERFUG, according to the type of material.