DEEP ENHANCER can be applied to natural stone with polished, brushed or brushed and flamed finish.

CHARACTERISTICS AND BENEFITS

•  Specifically for materials with low absorption
•  Strong colour-enhancing capacity
•  Penetrates deep inside the material
•  Leaves surfaces stain proof
•  Provides hydro-repellency to the surface
•  Ultra-resistant
•  Excellent water- and oil-repellent characteristics
•  Resistant to UV rays
•  Will not yellow over time
•  Adds a matt finish
•  Will not create a surface film
•  Also suitable for application outdoors.
•  Certified for food use
•  Ideal for application on wet areas (sauna, shower, washbasins, fountains)

This product can be used on both indoor and outdoor surfaces.
Suitable for use on: Granite, Limestone, Marble, Travertine, Craquelé ceramic, Glazed ceramic,
Marble-resin agglomerate, Quartz-resin agglomerate, Lapped porcelain stoneware. Polished
porcelain stoneware, Natural porcelain stoneware, Textured porcelain stoneware, Molten
basalt, and Clinker

The product is generally used on polished, brushed, aged surface, and in any case on low
absorbent material and compact superficial finishes. For application on more absorbent
surfaces, generally the product P 147 is advisable.

20/30 m2/l

Brush, Lambswool applicator, roller

Preparing and cleaning the surface

1. Carefully clean the surface, making sure to remove any dust or dirt present.

2. Never apply DEEP ENHANCER to wet or damp surfaces.

3. Apply DEEP ENHANCER to surfaces with a temperature of between +5 and +40°C

4. Any adjacent surfaces not being treated with the product must be protected.

Application 

5. Apply an even, abundant coat of product to a clean, dry surface with the preferred tool,
making sure to create an even layer to cover the whole surface being treated.

6. About 5-10 minutes after application, proceed to re-distribute the excess product using the
same tool used for application, taking care to achieve even coverage at the end of treatment.

7. About 20-30 minutes after applying the product proceed to remove all residues thoroughly,
making sure all excesses have been removed to prevent any possible problem of greasiness.
This operation is performed by brushing the surface, dry, using a standard floor polisher (1.5 HP,
175 rpm) with white or lambswool pad or wool-cotton attachment.

Alternatively, on tops, upright surfaces or small areas, residues can be removed with an orbital
or manual wheel, using a white disc or pad, or a compact felt or wool-cotton cloth.
To maximise the effectiveness of the stain-proofing treatment, the intensity of the colourenhancer and the durability of the treatment, it is possible to wait over 20-30 minutes, up to a
maximum of 45-60 minutes, before removing residues, to allow the product to penetrate fully
and deep down inside the structure of more compact materials. This way, the surface residues
may be slightly harder to remove.

Drying time

The product is fast drying and in any case, dries within 1-2 hours from application.

Opening to floor traffic

The surface can be opened to floor traffic about 4-6 hours after the product has been applied.

Complementary Cleaning and Maintenace Products

– For routine cleaning of a surface treated with DEEP ENHANCER we recommend: ALGAFLOOR

– For extraordinary cleaning of a surface treated with DEEP ENHANCER we recommend: FABER
30 or DETERFUG, according to the type of dirt.

– For de-waxing a surface treated with DEEP ENHANCER we recommend: DEC 21 and/or
DECERA/P