The product is not suitable for use on polished surfaces.

CHARACTERISTICS AND BENEFITS

•  Leaves surfaces stainproof
•  Provides hydro-repellency tot he surface
•  Provides oleo-repellency tot he surface
•  Strong colour-enhancing capacity
•  Brings out the characteristic veining on the surface
•  Ultra-resistant
•  Excellent water- and oil-repellent characteristics
•  Resistant to UV rays
•  Will not yellow over time
•  Increases surface shine

This product can be used on both indoor and outdoor surfaces.
Suitable for use on: Slate, sandstone, Basaltina – Lava rock, Cementina, Cotto, Granite,
Limestone, Marble, Reconstituted (eco) stone, Porphyry, Quarzite, Terracotta, Travertine, and
Tuff.
The product is not suitable for use on polished surfaces

15/20 m2/l

Brush, Lambswool applicator, roller

Preparing and cleaning the surface

1. Carefully clean the surface, making sure to remove any dust or dirt present.

2. Never apply MA 90 to wet or damp surfaces.

3. Apply MA 90 to surfaces with a temperature of between +5 and +40°C

4. Any adjacent surfaces not being treated with the product must be protected.

Application 

5. Apply an even, abundant coat of product to a clean, dry surface with the preferred tool,
making sure to create an even layer to cover the whole surface being treated.

6. Wait about 5-10 minutes and proceed to distribute any product excess on the application
area, taking care to even them out with the same tool, until the finished surface is even and
homogeneous. This operation may not be necessary on particularly absorbent surfaces.

7. After no less than 4-6 hours from application but in any case, on a completely dry surface, it is
possible to buff up the polished effect of MA 90 by dry brushing. This operation is performed by
brushing the surface, dry, using a standard floor polisher (1.5 HP, 175 rpm) with white or
lambswool disc or wool-cotton attachment. Alternatively, on tops, upright surfaces or small
areas, dry polishing is possible with an orbital or manual wheel, using a white disc or pad, or a
compact felt or wool-cotton cloth.

Drying time

The product is fast drying and in any case, dries within 1-2 hours from application.

Opening to floor traffic

The surface can be opened to floor traffic about 4-6 hours after the product has been applied.

Complementary Cleaning and Maintenace Products

– For routine cleaning of a surface treated with MA 90, we recommend: NEUGEL

– For routine cleaning of a surface treated with MA 90, we recommend: FABER 30 or DETERFUG,
according to the type of material.

– For dewaxing a surface treated with MA 90, we recommend: DEC 21 and/or DECERA P