CHARACTERISTICS AND BENEFITS

•  Brings out the shine and tone of the material
•  Effective protection against dirt and staining
•  Gives the floor excellent water- and oil-repellent characteristics
•  Excellent protection against foot traffic
•  Will not yellow
•  Applied quickly and easily
•  Brings out the full aesthetic qualities of the treated surface

Product suitable for indoor use.

Suitable for use on all surfaces previously treated with a water-based wax finish.

15/20 m2/l

Mop or lambswool cloth

Preparing and cleaning the surface

1. Carefully clean the surface, making sure to remove any dust or dirt present.

2. Never apply MANU’ to wet or damp surfaces.

3. Apply MANU’ to surfaces with a temperature of between +5 and +40°C

4. Any adjacent surfaces not being treated with the product must be protected.

The product is used diluted in clean water, according to the type of surface on which the wax
surface needs to be restored and the condition of the pre-existing wax layer.

For maintenance (regular treatment of a wax layer in good condition and with no specific signs
of wear):

– For compact and non-absorbent surfaces, such as textured stoneware and ceramics,
marble, granite, and natural stone with semi-polished finish and parquet, use in around
10% water (1 part product in 9 parts water);

– For textured, absorbent surfaces, such as cotto, terracotta, natural wood, marble,
granite, and tumbled natural stone with sanded or textured finish, use in around 20%
water (1 part product in 4 parts water);

To restore (treatment of a worn wax layer with signs of wear, scratches, abrasions, discolouring
and obvious aesthetic differences):

– For compact and non-absorbent surfaces, such as textured stoneware and ceramics,
marble, granite, and natural stone with semi-polished finish and parquet, use in around
20% water (1 part product in 4 parts water);

– For textured, absorbent surfaces, such as cotto, terracotta, natural wood, marble,
granite, and tumbled natural stone with sanded or textured finish, use in around 40%
water (2 parts product in 5 parts water);

Application 

5. MANU’ is applied with a wash and wax technique: apply a thin, even coat of previously
prepared solution to a clean, dry surface using a mop, squeezed out so that it leaves an even
layer of product without creating excessive build up. Make sure to create an even layer to cover
the whole surface being treated.

6. In case of particularly absorbent or rough surfaces, for a greater coverage or restoration
effect, it is possible to apply a second coat around 2-3 hours from the first.

7. MANU’ is a self-polishing wax that once applied, will create an extremely polished effect. In
the event you wish to increase the surface shine, it is possible to do so using a traditional
mechanical floor polisher with white or lambswool pad. Wait a minimum of 3-4 hours for the
wax to cure and then clean the surface dry, polishing until the required surface shine is
achieved. Using a mechanical polisher also makes it possible to clean up any flaws created by a
build-up of product in a specific surface area, in case of application of two coats of product.

Drying time

The product is fast drying and in any case no more than 1-2 hours from application.

Opening to floor traffic

The surface can be opened to floor traffic about 4-6 hours after the product has been applied.

Complementary Cleaning and Maintenace Products

– For routine cleaning of a surface treated with MANU’ we recommend: NEUGEL or ALGAFLOOR
For regular restoration of surfaces waxed with MANU, we recommend using MANU’ diluted to
1:5 in water

– For de-waxing a surface treated with MANU’, we recommend: DEC 21 and/or DECERA P