CHARACTERISTICS AND BENEFITS

•  Marked brightness
•  High hardness
•  Resistance to foot traffic
•  Fast result
•  Closure against soiling agents

For interiors and exteriors: Marbles, Limestone, Travertine, Granites, Quartz and Ceramics.

50/70 m2/lt

Single disc machine, which has a power of 2 HP (2.2 HP is preferable); Manual rotary brush.

Faber Chimica is able to supply the WARRIOR Single disc machine, which has a power of 2.2 HP,
and is optimised for the correct application of any product.

Preparing and cleaning the surface

1. Carefully clean the surface, making sure to remove any dust or dirt present.

2. Never apply ATS 60 to wet or damp surfaces.

4. Apply ATS 60 to surfaces with a temperature of between +5 and +40°C

5. Any adjacent surfaces not being treated with the product must be protected.

Application 

Test on a small area before proceeding, so to ensure product suitability and final result.

Proceed by small surface portions of about 1-2 sq.mt. each. Put 1-2 teaspoons of product on
the area to treat and make a dry-buffing, making concentric movement with a floor machine
and white pad. Continue until dry, by prolonging the movement with the machine to remove
possible residues. In order to obtain a higher brightness or superficial closing, repeat
application. The product does not give any superposition defect; therefore, once obtained the
maximum brightness, no defect can be remarked between two areas polished separately.

After polishing the surface, rinse with water and vacuum up the residues on the surface.