CHARACTERISTICS AND BENEFITS

•  Leaves a great depth of shine on treated surfaces
•  Drastically reduces the dirt on surfaces
•  Makes cleaning operations much easier
•  Does not change the surface hardness of the support
•  Boosts non-slip qualities on dry flooring
•  Quick and easy application
•  Even looking finished results
•  Sealing action on material porousness
•  Increases surface resistance to foot traffic
•  Water-based product.
•  Wax free
•  No defects through overlapping

This product can be used on both indoor and outdoor surfaces.
Suitable for use on: granite, siliceous stone

K400 NEW is suitable for application on all siliceous materials that have lost part of their shine
due to wear or foot traffic.

40/50 m2/kg

Single disc machine, which has a power of 2 HP (2.2 HP is preferable); Manual rotary brush

Faber Chimica is able to supply the WARRIOR single disc machine, which has a power of 2.2 HP,
and is optimised for the correct application of any product.

Preparing and cleaning the surface

1. Carefully clean the surface, making sure to remove any dust or dirt present.

2. We recommend proceeding to apply the product in stages, covering surfaces approximately 1m
2 at a time.

3. Never apply K400 NEW to wet surfaces. K400 NEW can be used on slightly damp surfaces;
therefore, please ensure that the surface to be treated is as dry as possible.

4. Apply K400 NEW to surfaces with a temperature of between +5 and +40°C

5. Any adjacent surfaces not being treated with the product must be protected.

Application 

K400 NEW is a white solid compound. It can be returned to its creamy state by shaking the
container. Different consistencies will in no way affect the finished results. The product can be
applied in both its solid or creamy states, since the rotary action of the polishing machine will in
any case return the product to its creamy consistency.

6. Pour a small amount of product directly onto the area to be polished. Generally, about 2/3
spoonfuls of product are enough to polish a surface area of 1 m2.

7. As soon as the product has been poured on, proceed to apply it to the surface using the
single disc machine, fitted with white pad and set to between 150 and 200 r.p.m. Pass the single
disc machine using concentric movements so as to distribute the product evenly over the whole
section being treated.

8. Continue to polish the same area until the product has dried completely (Dry Buffing
technique), taking care to broaden the movements outwards from the centre of the section so
as to cover the whole area evenly.

9. Pass on to the next section, repeating the polishing treatment process as described above.

10. After treating all of the surface areas, remove any steel wool residues from the surface using
a dry or damp cloth, a vacuum cleaner or a broom.

For better shine or to increase the sealing action of the material and therefore, its resistance to
dirt, repeat the application of the product following the same method stated above. Generally,
we recommend treating the same area with 1 or 2 applications of product, as required.

The product formulation will not cause overlap blemishes and therefore, once the maximum
surface shine has been achieved, there will be no difference or defects between the various
areas treated separately.

Drying time

10. After the product is completely dry, no further waiting time is necessary.

Opening to floor traffic

11. After the product is completely dry, the floor can be opened for use.

Complementary Cleaning and Maintenace Products

– For routine cleaning of a surface treated with K400 NEW, we recommend: NEUGEL or
ALGAFLOOR

– For routine cleaning of a surface treated with K400 NEW, we recommend: FABER 30 on marble
or lime-based materials or DETERFUG on ceramic or stoneware